Bore-Through Shaft Pins for Graphite Shafts

Our Pins are designed to finish graphite and steel shafts that are used for bore-through clubs.

You can epoxy or hammer them in the tip of the shaft and finish them off with acetone for a factory finish. We have improved many features in our graphite pins. We have increased the size. Due to the thin walled shafts that are now being used, we have added a Nail Head for easy installation and we changed the plastic composition so now there less cupping when sanding and buffing the sole of the club. Avoid other products, they have air holes that will leave a pin holes when sanding down the pin!!  Additionally, they shine up great with a little acetone.

Important Note: These pins are tapered, so remember to cut and contour the shaft tip in the head BEFORE YOU INSERT THE SHAFT PIN, (you don’t want to short cut the taper).
Remember to use acetone for a factory finish look.

There’s a Complete Chapter In the Billy Bob’s DVD Video on this Plug Installation.

• BB Code #: 12012