Bore-Through Shaft Pins for Steel Shafts


Our Pins are designed to finish Steel Shafts that are used for bore-through clubs.

In stock

Our Pins are designed to finish graphite and steel shafts that are used for bore-through clubs.

You can epoxy or hammer them in the tip of the shaft and finish them off with acetone for a factory finish. We have improved many features in our graphite pins. We have increased the size. Due to the thin walled shafts that are now being used, we have added a Nail Head for easy installation and we changed the plastic composition so now there less cupping when sanding and buffing the sole of the club. Avoid other products, they have air holes that will leave a pin holes when sanding down the pin!! Additionally, they shine up great with a little acetone.

Important Note: These pins are tapered, so remember to cut and contour the shaft tip in the head BEFORE YOU INSERT THE SHAFT PIN, (you don’t want to short cut the taper).
Remember to use acetone for a factory finish look.

Weight:0.2 lbs

  • BB Code #: 12014

What Our Clients Say

Based on 21 Reviews
Eric Chung
August 19, 2019

Justin from Billy Bob's helped me getting my clubs re-shafted. He was very considerate about getting swing weights to be the same throughout my iron set. I needed to change lie angles for the irons as well as my grips. Phenomenal job on the whole set and I respect his craftsmanship on the work he has done for my irons. I am glad I was able to visit this store and got this job done here.

Elite Mobile
April 14, 2023


Jimbo Franklin
December 9, 2023

Billy Bobs Golf is the Best Place for any Golfing Repair product and most All other Golfing needs. National Golf is Proud to say that Tish and everyone else at Billy Bobs is Above all the rest, by miles!!!

Our Partners