We feel that this .335-.350 Perforated Shaft Adaptor has become the industry standard for the club making trade. I know that there are many products out there, and some may have their merits. I’m talking about Springs, Plastic Sleeves and Brass Shims sleeves, Ours are Significantly Better!
Let’s face it’…some adaptors fail due to improper gluing, improper prepping, and the use of thin walled plastic that even prepping will cause damage to the part. How can you even get the proper prepping done? I’ve had some clubs returned to me that had Metal Brass Shims that caused the shaft to break in the hosel, even though there is good adhesion, there was failure due to metal contact on the graphite fibers. Additionally, springs have a tendency to collapse in the hosel when inserting the shaft, which leaves a void between the shaft and hosel. Then there are plastic sleeves, they can work but are hard to prep because of the wall thickness, which are extremely thin and are very hard to work with. We have developed the best of both worlds by allowing for good adhesion and proper preparation, most all of our adaptors have this Perforation Technology. The Proprietary Perforation allows the epoxy to bond between the prepped shaft tip and the prepped club hosel insuring a strong bond and the reinforced wall sections an added strength and flexibility. This adaptor comes with an attached ferrule to boot with a .560 outside diameter to cover “All hosels” on the market today!
INSTALLATION TIP: Make sure all debris is remove from the hosel (.350 reamer work’s perfectly), Dry-Fit the shaft into the adaptor and the hosel. Remember that it’s easier to remove a few thousandths from the shaft than to make an adjustment to the adaptor, and then glue everything at once. “Wall LA” turn down the ferrule and you’re good to go.