CMX ® TOUR FIT ADAPTER KIT INSTALLATION

CMX Tour Fit Adapter Sleeve Kit For Titleist 913 Driver, 910 D2/D3 and 910F This does not fit the 913 fairway woods

Epoxy Sleeve onto Shaft:
1. Slide the ferrule onto the shaft,
2. Place epoxy around the tip of the shaft
3. Place a small amount of epoxy inside the sleeve
4. Line up and slide the sleeve onto the shaft and join the ferrule with the sleeve.

*Make sure shaft and sleeve is prepped and
abraded for proper adhesion

Line up Sleeve Adapter:
1. After you slide sleeve onto shaft, line up the A-I (neutral) to your preferred alignment on the shaft (i.e. spline, grip orientation)
2. Clean excess epoxy with alcohol
3. Use may also use acetone on ferrule to bring out the shine.

Interchangeable Compound Collars
 1/4° Compound Collar
 1/2° Compound Collar
 3/4° Compound Collar

Compound Collar Installation
1. Remove the locking O-ring
2. Remove Compound Collar
3. Replace with your choice of Compound Collar

Compound Collar Placement
1. The Sleeve and Compound Collar have indicator dots. For proper orientation align the dots on the collar with the dot on the sleeve, if the Dots are not aligned the collar will not fit properly.
2. Install the supplied locking O-ring to secure the collar on the sleeve if you choose to do so.

Compound Collar Ring Adjustment After you have installed the selected collar you can adjust it to the preferred dialed position (See the next illustration and also refer to the CMX Adjustment Chart on the next page)