Callaway Loft and Lie Adapter Installation Manual

This Billy Bob’s loft and lie adaptor or (clock ferrule) will fit all the newer .350 hosel Callaway
clubs (VFT ERC II, Big Bertha II, Fusion, 460 X, FT5, FT 9, Ft i, FT iq and Diablo Driver (Not
the Diablo Edge or Razor Hawk it Takes FTiz Large Ferrule Adaptor) , and The New Octane it will also fit the I-MIX line of Callaway Drivers with the New Billy Bob’s I-MIX Sleeve. You must use a .335 shaft for this to work. You will need to remove all of the epoxy residue within the hosel to assure good adhesion and have room for the shaft and the ferrule to rotate to the desired position. If needed, you can use a .350 reamer to clean out the bottom portion, and a 7/16
drill or reamer to clean out the step down portion.There will be a missing mark on the ferrule (see Indicator Mark Missing Line illustration above). This is the indicator mark that will allow you to see which position you need to face the ferrule for loft and lie. Once you have achieved the proper angle, you can mark the top of the head so, when you glue the head and the shaft, you can go back to the position that you set.